Tungsten doped Barium Titanate (BT) with composition BaW0.05Ti0.95O3 (BWT) were prepared by using ball milling technique for different hours (10h, 20h and 30h). In the present paper, the microstructural, dielectric and impedance studies are discussed. The microstructural studies using XRD data reveals the formation of single phased tetragonal structure and perovskite structure. The dielectric properties […]
The present report describes the deposition of SiC-NiCr films on Zr substrates under an H2 gas environment by plasma focusing (PF). Using the spark plasma sintering (SPS) method, the anode for the plasma focus device was made from SiC, Ni, and Chromium powders. X-ray diffraction (XRD) of SiC-NiCr samples shows a change in the position and […]
AbstractThe ZnS thin films have been deposited by radio frequency magnetron sputtering at room temperature. Post-deposition rapid thermal annealing treatment was done for the films deposited at different powers ranging from 70 to 100 W. One peak is observed for as-deposited and annealed thin films at around 28.48° corresponding to the (111) reflection plane indicating a […]
AbstractIn this experimental study, a 1.5-kJ plasma focus device of Mather type was employed to grow titanium aluminum nitride (TiAlN) coatings at room temperature on 316 stainless steel sub-layer. The anode of the device was made of Titanium and Aluminium. A mixture of N2 and Ar gases was used as the work gas for TiAlN […]
AbstractThree steps anodization process is used to synthesize highly ordered and uniform multilayered titanium oxide (TiO2) nanotubes and effect of different anodization voltages are studied on their physical properties such as structural, morphological and optical. The crystalized structure of the synthesized tubes is investigated by X-ray diffractometer analysis. To study the morphology of the tubes, […]
AbstractEffect of aging on the properties of titanium dioxide nanoparticles produced by laser ablation process in water is investigated experimentally. The fundamental wavelength of a Q-switched Nd:YAG laser was employed to irradiate a high-purity Ti plate in distilled water at temperatures of 20, 35, 50 and 65 °C. Produced nanoparticles were diagnosed by UV–Vis–NIR spectroscopy, X-ray […]
AbstractCadmium telluride (CdTe) is a p-type II-VI compound semiconductor, which is an active component for producing photovoltaic solar cells in the form of thin films, due to its desirable physical properties. In this study, CdTe film was deposited using the radio frequency (RF) magnetron sputtering system onto a glass substrate. To improve the properties of […]
AbstractA 2.2-kJ Mather type plasma focus device charged at 18 kV was used to deposit titanium nitride on 304 type stainless steel substrates. The plasma focus device is fitted with solid titanium anode and operated with nitrogen as the filling gas. The process of deposition was done at room temperature, and samples were deposited at […]
AbstractSilver selenide (Ag2Se) thin films of thickness between 80 and 160 nm were prepared by thermal evaporation method. From XRD studies, the structure of the prepared film is confirmed to exhibit orthorhombic structure with polycrystalline nature. The average grain size of Ag2Se has been determined as 43 nm. EDAX spectra of these films were taken, and its […]