Magnesium hydroxide Mg(OH)2 nanorods with diameters of 90±10nm and lengths of more than 2μms were prepared by a simple route at ~75oC in ambient air. The approach is based on reaction of magnesium powder and de-ionized water without the use of any harmful, toxic or corrosive reagents. Characterization using X-ray diffraction (XRD) shows single crystalline […]
B1-xLaxFeO3 (x = 0.0, 0.025) crystallites were prepared by chemical solution route. XRD analysis confirmed the phase formation of the materials. Thermal characterization was done by DSC-TGA to confirm crystallization and thermal behavior for phase development. Morphological studies by FESEM showed the agglomerated nature of the ferrite and EDX analysis confirmed the degree of doping. […]
New two nano- sized Schiff base complexes [M(L)], where L= 2, 2'-((1E, 1E')-(1, 2 phenylen bis (azanylylidene)) bis (methanylylidene)) bis (4-bromo phenolato) and M=Cu or Zn, (a, b complexes) were synthesized by ultrasonic irradiation. These complexes were characterized by elemental analysis, molar conductivity, FT-IR, fluorescence emission, 1H NMR, field emission scanning electron spectroscopy (FESEM) and […]
Synthesizing plant-derived nanoparticles attract attention due to both their broad-spectrum biological applications and sustainable production. This paper describes the production of Cobalt oxide nanoparticles (Co3O4 NPs) using M. charantia leaf extract. The Uv–Vis absorption spectrum of them has peaks at 309 and 595nm. FTIR spectroscopy reveals bands at 580cm-1 and 667cm-1 and confirms the formation […]
This study aimed to use D-optimal combined design, and partial least squares discriminate analysis (PLS-DA) to investigate the mechanical properties, and chemical compatibilities of improved epoxy nanocomposites by nano TiO2/Al2O3. Experimental design of adhesion, and wedge bend properties led the results into the optimum values of TiO2= 0.66%, Al2O3= 1.33%, dispersant= 0.000017%. The variable importance […]
