The effect of Merpol surfactant on the morphology and performance of PES/PVP membranes: antibiotic separation

Authors

• Maryam Omidvar * ¹
• Zahra Hejri ²
• Ahmad Moarefian ³

1. Department of Chemical Engineering, Quchan Branch, Islamic Azad University, Quchan, Iran
2. Department of Chemical Engineering, Quchan Branch, Islamic Azad University, Quchan, 94791-76135, Iran
3. Chemical Engineering Department, Faculty of Petroleum, Gas and Petrochemical Engineering, Persian Gulf University, Bushehr, 7516913798, Iran

Abstract

The present study used modified nanofiltration (NF) membranes to remove the emerging contaminant of amoxicillin (AMX) from synthetic wastewater. For this purpose, Merpol surfactant and polyvinylpyrrolidone were added to the casting solutions to prepare flat sheet asymmetric polyethersulfone (PES) NF membranes through phase inversion process. Then, the effect of adding Merpol surfactant at different concentrations on the morphology, hydrophilicity, and pure water flux (PWF) of the membranes, as well as the separation of AMX from aqueous solutions was investigated. The characteristics of the prepared membranes were studied by scanning electron microscopy (SEM), field emission scanning electron microscopy (FESEM), contact angle (CA) measurement and performance tests. The obtained results approved the improved hydrophilicity of the PES membranes after adding Merpol surfactant to the casting solution. The findings also revealed a gradual increase in the average size of the membrane pores in sub-layer and thinner top layer, proportional to the increase of surfactant content in the solution. The results also confirmed the increase of PWF under the influence of surfactant increase. As a result, for the membrane containing 8 wt% Merpol additive, the lowest CA (52.08°), the highest PWF (76.31 L/m² h), and maximum AMX excretion (97%) were achieved.

Keywords

• Polyethersulfone membrane
• Antibiotic
• Hydrophilicity
• Merpol
• Nanofiltration