Induction motors are widely used in industrial, commercial and residential applications. An induction motor may exposed to the unbalanced voltage in the various operating conditions. Therefore, it is vital to investigate influences of voltage unbalance on performance of induction motors. In this paper, the performance of a three-phase squirrel cage induction motor has been simulated […]
The demand for RFID tags has recently increased due to the development of the RFID. Over the past decade, great efforts have been devoted to the design of RFID tags without chip inside. The concept of chipless RFID tags appears to be a promising solution for low cost item tagging because the cost of active […]
In this paper an approach is presented for edge detection of noisy images that have been degraded by impulsive noise. It uses Fuzzy Inference System (FIS) and Ant Colony Optimization (ACO). Starting with, using the FIS with 12 simple rules is to identify the noisy pixels in order to perform the filtering operation only for […]
With respect to the increasing growth in the subscribers of wireless cellular networks and the necessity of providing network services with reasonable quality in any location, the importance of enhancement in the wireless network services is deeply felt. This means that network users expect to receive voice, data, and multimedia services with reasonable QoS, regardless […]
In this paper, the multi-machine power system is simulated and in addition, VURPSO optimization algorithm is used to optimize the parameters of simultaneous controllers of Static Var Compensator (SVC) and power system stabilizer (PSS) in order that the power system stability increases. By SVC, the transferrable power in steady state can be increased and the […]
In this paper optimum size and location of capacitors and distributed generators (DGs) are determined for reliability improvement and power loss reduction using genetic algorithm (GA). The main innovation of this paper is using both of DG and Capacitor for the reliability improvement and power loss reduction. For this purpose an objective function consisting of […]
In this paper a hybrid and practical method is provided to allocation and capacity determination combined heat and power (CHP) generator at a bus. This method consists of two stages. Firstly, Through the bus thermal coefficient, the suitable buses will be found for CHP installation. This coefficient indicates the possibility of heat selling around each […]
Multi-input multi-output-orthogonal frequency-division multiplexing (MIMO-OFDM) is known as a proper solution for wideband wireless communication. Numerous space-frequency block codes (SFBCs) and space-time-frequency block codes (STFBCs) have been proposed so far for implementing MIMO-OFDM systems. In this paper, a new full-diversity STFBC is proposed for two transmit antennas, which could benefit from the maximum coding advantage […]
Electrochemical impedance spectroscopy (EIS) is a very powerful tool for exploitation as a rich source of Proton Exchange Membrane Fuel Cell (PEMFC) diagnostic information.A primary goal of this work was to develop a suitable PEMFC impedance model, which can be used in the analysis for flooding and drying of fuel cell. For this one a […]
An integration technique based on use of Monte Carlo Integration (MCI) is proposed for the analysis of electromagnetic radiation from apertures. The technique that can be applied to the calculation of aperture antenna radiation patterns is the equivalence principle followed by physical optics, which can then be used to compute far-field antenna radiation patterns. However, […]
