Eco-sustainable routing of power lines for the connection of renewable energy plants to the Italian high-voltage grid
Abstract
Abstract
Routing of high-voltage electric transmission lines for the connection of renewable energy-distributed generation plants is a critical issue from an environmental point of view. A standard methodology that accounts for multiple perspectives, influence factors and is able to mediate between weighted constraints can be a useful tool for the regulating bodies that are involved in approval processes. The methodology can be an effective support to increase reliability, save consumers' money and mitigate the unavoidable impacts of the lines on the population living nearby. In this paper we investigate the suitability of a procedure employed by Terna, the Italian high-voltage transmission system operator, to identify the corridors where to route new overhead transmission lines with the lowest environmental impact. The methodology is based on the subdivision of all the relevant constraints dictated by environmental issues and territory legislations in four main classes. A real case study concerning the design and connection of a wind farm placed near Collarmele, in the center of Italy, shows the effectiveness of the proposed methodology.
Keywords
- Connection assessment,
- Overhead power lines,
- Distributed generation,
- Wind farm
References
- Abam et al. (2014) Energy resource structure and on-going sustainable development policy in Nigeria: a review 5(2) (pp. 1-16) https://doi.org/10.1007/s40095-014-0102-8
- Adaramola and Oyewola (2011) Evaluating the performance of wind turbines in selected locations in Oyo state, Nigeria 36(12) (pp. 3297-3304) https://doi.org/10.1016/j.renene.2011.04.029
- Araneo and Falconi (2013) Lateral bending of tapered piezo-semiconductive nanostructures for ultra-sensitive mechanical force to voltage conversion 24(26) https://doi.org/10.1088/0957-4484/24/26/265707
- Araneo et al. (2014) Assessment of a practical model to estimate the cell temperature of a photovoltaic module (pp. 1-15) https://doi.org/10.1007/s40095-014-0072-x
- Araneo et al. (2009) EMC issues in high-power grid-connected photovoltaic plants (pp. 639-648) https://doi.org/10.1109/TEMC.2009.2026055
- Araneo et al. (2012) Piezo-semiconductive quasi-1D nanodevices with or without anti-symmetry 24(34) (pp. 4719-24) https://doi.org/10.1002/adma.201104588
- Araneo, R., Bini, F., Pea, M., Notargiacomo, A., Rinaldi, A., Lovat, G., Celozzi, S.: Current-voltage characteristics of ZnO nanowires under uniaxial loading. IEEE Trans. Nanotechnol.
- 13
- (4) (2014)
- Celozzi (2002) Active compensation and partial shields for the power-frequency magnetic field reduction (pp. 222-226)
- Celozzi and Garzia (2003) Magnetic field reduction by means of active shielding techniques (pp. 79-89)
- Celozzi and Garzia (2004) Active shielding for power-frequency magnetic field reduction using genetic algorithms optimisation 151(1) (pp. 2-7) https://doi.org/10.1049/ip-smt:20040002
- de Araujo Lima and Bezerra Filho (2010) Wind energy assessment and wind farm simulation in Triunfo–Pernambuco, Brazil 35(12) (pp. 2705-2713) https://doi.org/10.1016/j.renene.2010.04.019
- Eddine and Salah (2012) Solid waste as renewable source of energy: current and future possibility in Algeria 3(1) https://doi.org/10.1186/2251-6832-3-17
- Commission, European: Renewable Energy Directive 2009/28/EC. In: Proceedings of European Parliament and of the Council, Technical Report (2009)
- European Commission: Communication from the Commission to the European Parliament, the Council, the European Economic and social committee and the Committee of the regions: a roadmap for moving to a competitive low-carbon economy in 2050. Technical report, European commission SEC, 288 final (2011)
- European Commission: Communication from the Commission to the European Parliament, the Council, the European Economic and social committee and the committee of the regions: energy roadmap 2050, Technical report, European commission COM, 885 final (2011)
- European Commission: Communication from the Commission to the European Parliament, the Council, the European economic and social committee and the committee of the regions: impact assessment-energy roadmap 2050, Technical report, European commission SEC, 1565 final (2011)
- Ferreira et al. (2014) Life cycle assessment of residual forestry biomass chips at a power plant: a Portuguese case study 5(2) (pp. 1-7) https://doi.org/10.1007/s40095-014-0086-4
- Fischer (2007) Earthscan
- Flodberg et al. (2012) Low-energy office buildings using existing technology: simulations with low internal heat gains 3(1) (pp. 1-9) https://doi.org/10.1186/2251-6832-3-19
- Hurtado et al. (2014) Methodological development of a probabilistic model for CO2 geological storage safety assessment 5(2) (pp. 1-10) https://doi.org/10.1007/s40095-014-0084-6
- Jacobsen et al. (2014) Cooperation mechanisms to achieve EU renewable targets (pp. 345-352) https://doi.org/10.1016/j.renene.2013.09.035
- Lal and Raturi (2012) Techno-economic analysis of a hybrid mini-grid system for Fiji islands 3(1) (pp. 1-10) https://doi.org/10.1186/2251-6832-3-10
- Lean and Smyth (2013) Will policies to promote renewable electricity generation be effective? Evidence from panel stationarity and unit root tests for 115 countries (pp. 371-379) https://doi.org/10.1016/j.rser.2013.01.059
- Lucchetti et al. (2013) Assessment of the technical usable potential of the TUM Shaft Hydro Power plant on the Aurino River, Italy (pp. 648-654) https://doi.org/10.1016/j.renene.2013.06.015
- Melikoglu (2013) Vision 2023: feasibility analysis of Turkey’s renewable energy projection (pp. 570-575) https://doi.org/10.1016/j.renene.2012.07.032
- Menegaki (2013) Growth and renewable energy in Europe: benchmarking with data envelopment analysis (pp. 363-369) https://doi.org/10.1016/j.renene.2013.05.042
- Pang et al. (2014) Energy models from a strategic environmental assessment perspective in an EU context: what is missing concerning renewables? (pp. 353-362) https://doi.org/10.1016/j.rser.2014.02.005
- Quinonez-Varela et al. (2007) A GIS/PSS planning tool for the initial grid connection assessment of renewable generation 32(5) (pp. 727-737) https://doi.org/10.1016/j.renene.2006.03.011
- Rinaldi, A., Araneo, R., Celozzi, S., Pea, M., Notargiacomo, A.: The clash of mechanical and electrical size-effects in ZnO nanowires and a double power law design concept for piezoelectric and piezotronic devices. Adv. Mater. (2014). doi:
- 10.1002/adma.201401026
- Shafiullah et al. (2012) Prospects of renewable energy: a feasibility study in the Australian context 39(1) (pp. 183-197) https://doi.org/10.1016/j.renene.2011.08.016
- Sharma and Harinarayana (2012) Enhancement of energy generation from two layer solar panels 3(12) (pp. 1-9)
- Sharma and Harinarayana (2013) Solar energy generation potential along national highways 4(16) (pp. 1-13)
- Sims and Dent (2005) High-voltage overhead power lines and property values: a residential study in the UK 42(4) (pp. 665-694) https://doi.org/10.1080/00420980500060541
- Whitworth et al. (2001) Aerial video inspection of overhead power lines 15(1) (pp. 25-32) https://doi.org/10.1049/pe:20010103
- Zangl, H., Bretterklieber, T., Brasseur, G.: Energy harvesting for online condition monitoring of high-voltage overhead power lines. In: Proceedings of Instrumentation and Measurement Technology Conference, 2008, IMTC 2008. IEEE, pp. 1364–1369 (2008)
10.1007/s40095-014-0143-z