Application of Levenberg-Marquardt Backpropagation Algorithm in Artificial Neural Network for Self-Calibration of Deflection Type Wheatstone Bridge Circuit in CO Electrochemical Gas Sensor

Abstract

The unique properties of carbon monoxide and its high combustibility have led to the creation of various ‎sensors, such as electrochemical sensors and different circuits, to read its output. In this article, a deflection-type ‎Wheatstone bridge is used to measure changes in the sensor resistance, and the output voltage is connected to a 12-‎bit analog-to-digital converter through an adjustable precision amplifier. Next, a new method is proposed for self-calibrating the CO sensor. The Levenberg-Marquardt backpropagation algorithm (LMBP) is utilized in the Artificial ‎Neural Network model to minimize the Mean Squared Error (MSE) and identify the most suitable parameters in the ‎proposed method.‎‏ ‏The model under consideration has been developed and trained using real-time data.‎‏ ‏Based on ‎the experimental and evaluation outcomes, it can be concluded that the suggested model has an MSE value of ‎‎0.28249 and an R2 coefficient of determination of 0.99992, indicating high accuracy and precision. The proposed ‎sensor and calibration method have potential applications in various applications, including industrial and domestic ‎environments where CO monitoring is necessary.‎

References

[1]     J. Rivera, G. Herrera, M. Chacón, P. Acosta, and M. Carrillo, “Improved Progressive Polynomial Algorithm for Self-Adjustment and Optimal Response in Intelligent Sensors, ” Sensors, Vol. 8, No. 11, pp. 7410-7427, 2008.

[2]     J. Rivera, M. Carrillo, M. Chacón, G. Herrera, and G. Bojorquez, “Self-Calibration and Optimal Response in Intelligent Sensors Design Based on Artificial Neural Networks, ” Sensors, Vol. 7, No. 8, pp. 1509-1529, 2007.

[3]     S. M. A. Zanjani, M. Aalipour, and M. Parvizi. “Design of a Low Power Temperature Sensor Based on Sub-Threshold Performance of Carbon Nanotube Transistors with an Inaccuracy of 1.5 ºC for the range of-30 to 125ºC. ” Journal of Intelligent Procedures in Electrical Technology, Vol. 13, No. 50 pp. 115-127 , 2022.

[4]     G. Farias et al., “A Neural Network Approach for Building An Obstacle Detection Model by Fusion of Proximity Sensors Data, ” Sensors, Vol. 18, No. 3, p. 683, 2018.

[5]     J. R. Rivas, F. Lou, H. Harrison, and N. Key, “Measurement and calibration of centrifugal compressor pressure scanning instrumentation, ” 2015.

[6]     A. Sharafat, et al. “Low-Cost CO Sensor Calibration Using One Dimensional Convolutional Neural Network” Sensors, Vol. 23, No. 2, p854, 2023.

[7]     J. Baranwal, et al. “Electrochemical sensors and their applications: A review, ” Chemosensors, Vol. 10, No. 9, p. 363, 2022.

[8]     V.Tangirala, et al. “A study of the CO sensing responses of Cu-, Pt-and Pd-activated SnO2 sensors: effect of precipitation agents, dopants and doping methods, ” Sensors, Vol. 17, No. 5, p. 1717, 2011.

[9]     Mallampati, S. B., & Seetha, H. “A Review on Recent Approaches of Machine Learning, Deep Learning, and Explainable Artificial Intelligence in Intrusion Detection Systems, ” Majlesi Journal of Electrical Engineering, Vol. 17, No. 1, pp. 29-54, 2023.

[10]  K. F. Lyahou, G. van der Horn, and J. H. Huijsing, “A noniterative polynomial 2-D calibration method implemented in a microcontroller, ” IEEE Transactions on Instrumentation and Measurement, Vol. 46, No. 4, pp. 752-757, 1997.

[11]  J. D. Pereira, O. Postolache, and P. S. Girao, “Adaptive self-calibration algorithm for smart sensors linearization,” IEEE Instrumentation and Measurement Technology Conference Proceedings, Vol. 1, pp. 648-652, 2005.

[12]  N. Abu-Khalaf and J. J. L. Iversen, “Calibration of a sensor array (an electronic tongue) for identification and quantification of odorants from livestock buildings, ” Sensors, Vol. 7, No. 1, pp. 103-128, 2007.

[13]  H. Adeli, “Neural networks in civil engineering: 1989–2000,” Computer‐Aided Civil and Infrastructure Engineering, Vol. 16, No. 2, pp. 126-142, 2001.

[14]  H. Ghadiri, “Real-time Stability Assessment of Power System using ANN without Requiring Expert Experience, ”  Majlesi Journal of Electrical Engineering, Vol. 14, No. 2, pp.  43-49, 2020.

[15]  S. B.  Mallampati,and H. Seetha, “A Review on Recent Approaches of Machine Learning, Deep Learning, and Explainable Artificial Intelligence in Intrusion Detection Systems,” . Majlesi Journal of Electrical Engineering, Vol. 17, No. 1, pp. 29-54, 2023.

[16]  S. M. A. Zanjani, H. Shahinzadeh, J. Moradi, M. Fayaz-dastgerdi, W. Yaïci, and M. Benbouzid. “Short-term Load Forecasting using the Combined Method of Wavelet Transform and Neural Networks Tuned by the Gray Wolf Optimization Algorithm,” Global Energy Conference (GEC), IEEE, pp. 294-299, 2022.

[17]  A. Al-Salaymeh, “Optimization of hot-wire thermal flow sensor based on a neural net model,” Applied thermal engineering, Vol. 26, No. 8-9, pp. 948-955, 2006.

[18]  A. S. Ciminski, “Neural network based adaptable control method for linearization of high power amplifiers,” AEU-International Journal of Electronics and Communications, Vol. 59, No. 4, pp. 239-243, 2005.

[19]  A. Ramadan Suleiman and M. L. Nehdi, “Modeling self-healing of concrete using hybrid genetic algorithm–artificial neural network,” Materials, Vol. 10, No. 2, p. 135, 2017.

[20]  Y. H. Hu and J.-N. Hwang, “Introduction to neural networks for signal processing,” in Handbook of neural network signal processing: CRC press, p. 1, 2018.

[21]  B. Erhan, C. Oral, and E. Ufuk Ergül. “Classification of arithmetic mental task performances using EEG and ECG signals,” The Journal of Supercomputing, pp. 1-13, 2023.

[22]  A. Depari, A. Flammini, D. Marioli, and A. Taroni, “Application of an ANFIS algorithm to sensor data processing,” IEEE Transactions on Instrumentation and Measurement, Vol. 56, No. 1, pp. 75-79, 2007.

[23]  A. Depari et al., “Digital signal processing for biaxial position measurement with a pyroelectric sensor array,” IEEE transactions on instrumentation and measurement, Vol. 55, No. 2, pp. 501-506, 2006.

[24]  A. M. Almassri, W. Z. Wan Hasan, S. A. Ahmad, S. Shafie, C. Wada, and K. Horio, “Self-calibration algorithm for a pressure sensor with a real-time approach based on an artificial neural network,” Sensors, Vol. 18, No. 8, p. 2561, 2018.

[25]  A. Asilian, S. M. A. Zanjani. “Design and fabrication of an amperometric CO gas sensor and a readout circuit using a low-noise transimpedance amplifier to achieve standard analog outputs,” AEU-International Journal of Electronics and Communications, Vol. 171, p. 154864, 2023.

[26]  Wozniak, L., Kalinowski, P., Jasinski, G., & Jasinski, P. (2018). “FFT analysis of temperature modulated semiconductor gas sensor response for the prediction of ammonia concentration under humidity interference,” Microelectronics Reliability, Vol. 84, pp. 163-169, 2018.

[27]  Burgués, J., Esclapez, M. D., Doñate, S., & Marco, S. “ RHINOS: A lightweight portable electronic nose for real-time odor quantification in wastewater treatment plants, ”. IScience, Vol. 24, No. 12, 2021.

[28]  Wang, J., Lian, S., Lei, B., Li, B., & Lei, S. “Co-training neural network-based infrared sensor array for natural gas monitoring,” Sensors and Actuators A: Physical, Vol. 335, pp. 113392, 2022.

[29]  Chen, K., Liu, L., Nie, B., Lu, B., Fu, L., He, Z., . & Liu, H. “Recognizing lung cancer and stages using a self-developed electronic nose system,” Computers in Biology and Medicine, Vol. 131, p. 104294, 2021.

[30]  Srinivasan, P., Robinson, J., Geevaretnam, J., & Rayappan, J. B. B. (2020). “Development of electronic nose (Shrimp-Nose) for the determination of perishable quality and shelf-life of cultured Pacific white shrimp (Litopenaeus Vannamei),” Sensors and Actuators B: Chemical, Vol. 317, pp. 128192, 2020.

[31]  Bax, C., Prudenza, S., Gutierrez-Galvez, A., & Capelli, L. “Drift compensation on electronic nose data relevant to the monitoring of odorous emissions from a landfill by opls,” Chemical Engineering Transactions, Vol. 85, pp. 13-18, 2021.

[32]  Valcárcel, M., Ibáñez, G., Martí, R., Beltrán, J., Cebolla-Cornejo, J., & Roselló, S. “Optimization of electronic nose drift correction applied to tomato volatile profiling, ” Analytical and Bioanalytical Chemistry, Vol. 413, No. 15, pp. 3893-3907 , 2021.

[33]  Liang, Z., Xue, Q., Tian, F., Xu, C., Wang, C., Yang, L., & Guo, T. “A sparse reconstruction domain transfer method for interference suppression in artificial olfactory system,” IEEE Sensors Journal, Vol. 22, No. 7, pp. 6717-6730 , 2022.

[34]  Zhu, X., Liu, T., Chen, J., Cao, J., & Wang, H. “One-Class Drift Compensation for an Electronic Nose,” Chemosensors, Vol. 9, No. 8, p. 208, 2021.

[35]  Yi, Z., Shang, W., Xu, T., & Wu, X. “Neighborhood preserving and weighted subspace learning method for drift compensation in gas sensor,” IEEE Transactions on Systems, Man, and Cybernetics: Systems, Vol. 52, No. 6, pp. 3530-3541, 2021.