A simple and green method based on chemical fragmentation of wood charcoal is used to produce carbon quantum dots (CQDs). These CQDs are used to form a nanocomposite with synthesized titanium dioxide nanoparticles (TiO2/CQDs). The X-ray diffraction (XRD) analysis of this TiO2/CQDs nanocomposite has revealed that the presence of CQDs in these TiO2/CQDs does not […]
The present work reports the Hirshfeld surface analysis and photocatalytic performance of NiFe2O4 nanomaterial. Hirshfeld surface analysis was performed to understand the interaction properties of the NiFe2O4 compound. The active sites including π-π interactions are studied by the analysis. The Hirshfeld data showed that the two wings in the O…O and O…Ni diagrams are created […]
In the last decade, the bio-assisted synthesis of nanoparticles has been significantly exploited seeing the shortfall of chemical synthesis and urgent need to find the substitution. The chemical synthesis of nanoparticles is a rapid process, which might be appealing in various frontiers but has got some serious issues to take care of. In pursuit of […]
Full adder cells are the major fundamental elements of larger arithmetic circuits, which are mostly located along the critical path of circuits. Therefore, the design of low-power and high-speed full adder cells is critical. In this paper, there are two new inexact full adder cells proposed based on Carbon Nanotube Field Effect Transistor (CNFET) technology. Using the HSPICE simulator […]
This paper deals with the synthesis of copper oxide (CuO) nanoparticles by the plant-mediated method using copper acetate monohydrate and neem extract. The formation of nanoparticles was confirmed by UV-Visible spectral studies. P-XRD studies revealed that the average particle size of synthesized nanoparticles was 11.30 nm which was in good agreement with TEM results. Morphology […]
A successful drilling operation depends strongly on a useful drilling fluid system. Using nanoparticles (NP)s to formulate intelligent drilling fluids gives them a wide range of optimal properties under different operating conditions and resolves any operational problems. In this study, in order to provide an effective solution for improving the rheological and high pressure/high temperature […]
Green synthesis of metal nanoparticles (MNPs) is attracting the attention of chemists as it is cost effective and environment benign technique. Hence it is preferred to methods which use toxic reagents in the synthesis of MNPs. In. In this study, copper oxide nanoparticles (Cu2ONPs) were synthesized using Allium cepa (AC) and Raphanus sativus (RS) aqueous […]
The synthesis of bis(indolyl)methane derivatives in the reaction between indoles and aldehydes was carried out in a short reaction time (10-20 minutes) with good yield (78-96%) by using 1 mol% of nanoγ-Al2O3in H2O as a green solvent at room temperature. Moreover, we usednanoγ-Al2O3 as an effortlessly accessible, less costly, and possible under eco-friendly conditions catalyst […]
In this paper, the design of a novel low-power Min/Max circuit using Carbon Nanotube Field-Effect Transistor (CNTFET) technology has been discussed. By employing a new structure for the implementation of digital comparator, a high performance configuration has been obtained which consumes small area on chip due to the low transistor count used for its implementation. […]
The present investigation evaluates the potential of aqueous seed extract of Abrus precatorius L. for the biosynthesis of silver nanoparticles (AgNPs). The structure of AgNPs was authenticated by the changes in colour as well as the UV-vis spectroscopy, which showed an absorbance maxima peak at 441 nm. The scanning electron microscope (SEM) investigation proved the […]